1. Prepare 1 set of  2 tone color melamine molding machine with 1 set of preheater machine

2. Preheat powder into cake A and put into the mold

3. Press the button of curing and A color punch moving to close with cavity 

4. Preheat powder into cake B

5. Mold open automatically, punch A moves back and punch B comes

6. Put cake B into the cavity and press the button of curing again, then punch B and cavity closed  

7. Mold open automatically, if you have paper to put, then place the paper into the mold, and then press the button of paper

8. Mold open automatically, spread the glazing powder and then press the button of Glazing, mold close again

9. Mold open automatically, get out the finished product and clean the mold by air-gun.

Shunhao machines to press the melamine tableware is higher, and almost the machines needs to be lower to ship into the container: 

20GP container can ship the 150 tons or 200tons machines; 

40HQ can ship all the models of molding machines.

If you have other small parts to ship together, can send to our factory to ship with machines.Normally, 40HQ container can ship 3-5 sets of molding machines.

300 tons pressing machine / 800*760mm plate size / Total power of machine 28.2kw

1.To make urea tableware: approx.411kw per 24 hours

2.To make pure melamine tabelware: approx.391kw per 24 hours

1. The oil-cut  port of high low  pump is not locked; Use a spanner to lock it tightly

2. Oil in oil tank insufficient; Supplement well the oil

3. Oil pipes in oil cylinder broken; Fix the broken pipe or replace it

1. The switch has oil leakage; replace the oil seal

2. The relief valve is stuck; can remove and clear it

3. The valve of pre-fill valve damaged; replace it

4. The anti-reverse valve for pressurization cannot maintain pressure; replace it

Air switch tripping due to overloading; Check for shorts or overuse (50A), just replace it

It's because one wire of 3 wires three-phase is broken or off. We can change the new wire and connect.

You could take the following steps to check and solve the problem.

1. Check whether the power is off, then switch the power on

2. Motor rotation direction wrong; Change to connect any 2 of 3 pcs of power wires

3. Hydraulic oil insufficient; Filling enough oil

4.Thermal replay tripping over motor load; Switch on the blue reset button of thermal relay